nspec_innovationsTX22 V3 FRT With Striker Housing Upgrade We offer the newest, upgraded TX22 FRT V3 design that features a larger hole and more defined edges to reduce wear on your TX22 over time. (pictured in the pictures with the striker housing) Want to go all out for your TX22 setup? Add our NSPEC Innovations Taurus TX22 (.22 LR) Striker Housing Set — Left & Right (Replacement) Replace worn or heat-damaged factory parts with this complete left/right striker housing set, designed to fit all Taurus TX22 variants, including Gen 1 and Gen 2 models. Manufactured by NSPEC Innovations, these housings are built for high-performance use. The material provides heat resistance up to 565°F, and the internal channel is printed to a smooth finish to promote consistent, low-friction striker travel. We also refined the geometry by enlarging the striker block cavity, addressing a common contributor to inconsistent striker movement and potential misfires—especially in setups that run higher cyclic demands. Important note for FRT users: With prolonged, high-rate use, the striker housing can become a consumable part. Factory housings may soften or deform under sustained heat; these replaceable housings are intended to help mitigate that. For FRT applications, plan on routine inspection and replacement as needed. WORKS IN: 2TX22, 2TX22C, TX22, TX22C (Competition/T.O.R.O) (ALL MODELS/ALL GENS) Bulk Pricing Below are the available bulk discount rates for each individual item when you purchase a certain amount Buy 2 - 4 and get 20% off Buy 5 - 9 and get 25% off Buy 10 or above and get 30% off
