Listing a bit of a project. A 308 Saiga Ak that I started to finish a conversion on that was attempted. I had the barrel cut to 12.5in, crowned and installed a PSA front sight combo gas block. “Permanently” attached booster to bring it to 16in overall length, ready to form 1! a ALG enhanced trigger, Jmac 1913 stock adapter, CSS 20 round magazine and Russian 8 rounder, tango down grip. It NEEDS 1 rivet for the rear trunion due to the sight rail delete, and a hand guard solution. AKstuff has a Zenitco hand guard for the RPK rifles, and then a bolt on hand guard retainer as this is a very thick barrel. Will comes with a krebs enhanced safety selector. All the sight rail holes were welded over and pretty nicely blended. However if you look hard enough, the bottom one for the hand guard is slightly visible. Asking $1500 shipped.
